Drayton digistat scr instructions manual

Drayton Digistat+1 manual 1. Install (see installation instructions) and turn power on to the SCR (receiver). If a separate programmer is fitted, 2. Push the ‘override ’ button on the SCR once. The green LED should also come on. Check to see if the boiler and/or 3. T o enter ‘learn’ mode push 89%(1). Drayton Digistat +3RF Invensys Controls Europe Customer Service Tel: 08Customer Service Fax: 08 Digistat SCR T Certification Mark. The Digistat +3RF thermostat is a programmable thermostat To exit manual mode press once, to return to auto. To change temperature for a short period (Override): 1. Press + or - buttons to. indicate “low battery” during this time the Digistat +1RF will function normally (see fig 1). Please replace batteries with 2 x V IEC LR6 (AA) Alkaline batteries. When the battery icon alone is shown in the display, the batteries are completely exhausted and the Digistat +1RF will .

Digistat RF units are matched correctly to the relevant SCR. This is easily achieved by commissioning each Digistat and SCR in turn. 1. Install (see installation instructions) and turn power on to the SCR (receiver). If a separate programmer is fitted, ensure that it is switched on. The red LED should come on. 2. Digistat+C RF Boost 1 Hr BOILER 30cm Min Preferred side of boiler The range may be affected by composition/density and number of walls between the Digistat +CRF and SCR V a.c. V a.c. Digistat+C RF Heating Radio Signal Range: 30m Typically SCR Technical Helpline: +44 (0) www.doorway.ru Email: www.doorway.ru reposition the Digistat +2RF/+3RF until the RED LED is flashing. When the signal strength has been confirmed remove the batteries to cancel the test and follow the installation instructions as follows. 1. Turn off the power supply to the Digistat SCR (receiver unit) and leave for 5 seconds. Turn on power to SCR unit and check red light is.

User Instructions. The Digistat +3RF thermostat is a programmable thermostat. Day / 7 Day product. 5–2 day allows you to set a program for. weekdays and a program for the weekend. Full 7-day functionality. a. llows you to set a different program for every day of the week. E. final location of the Digistat +RF room thermostat and not less than 30cm from the boiler side panel. Warning: Installing the SCR too close to the metal side panel or mains cables may interfere with the radio signal. 1. Loosen the securing screws, remove the wallplate, and if surface wiring is to be used, snap out the cable entry strip on the bottom. Prior to commencing the installation you must ensure the mains supply is switched off. Do not install the Digistat +RF transmitter until after you have completed thecommissioning process. Pull down the battery drawer in the Digistat unit and the screen will go blank. Turn off the power supply to the.