Dixell xr20 manual

Model XR20C, format 32 x 74 mm, is a digital thermostat with off cycle defrost designed for. refrigeration applications at normal temperature. It provides a relay output to drive the. compressor. It is also provided with 2 NTC or PTC probe inputs, the first one for temperature. HOW TO START A MANUAL DEFROST Push the DEF key for more than 2 seconds and a manual defrost will start. HOW TO CHANGE A PARAMETER VALUE To change the parameter’s value operate as follows: 1. Enter the Programming mode by pressing the Set and DOWN key for 3s (and start blinking). 2. Select the required parameter. 3. Dixell Electronic Controllers This booklet has been produced to assist you with the setting up and programming of Dixell Controllers. It is not designed to totally replace the manufacturer’s manual, but rather to compliment it. Please refer to the manufacturer’s manual when in any doubt.

MANUAL AGITATION CYCLE It can be started by means of the o key, by holding it pressed for 3 seconds. Agitator remains ON for the time set in Agt parameter. The compressor keeps with the normal regulation. 4. FRONT PANEL COMMANDS SET: To display target set point; in programming mode it selects a parameter or confirm an operation. problem by creating the Dixell™ Universal-XR controller. This dual-supply voltage controller is capable of replacing thou-sands of SKUs, including more than of the most common 32x74 mm format controllers. The most typical applications can be back up and running quickly — often in just a few minutes — regardless of. dIXEL Operating Manual XR06CX GB r doc XR06CX 2/3 8. PARAMETERS REGULATION Hy Differential: (0,1°C ÷ 25°C / 1°F ÷ 45°F) Intervention differential for set www.doorway.russor Cut.

HOW TO START A MANUAL DEFROST Push the DEF key for more than 2 seconds and a manual defrost will start. HOW TO CHANGE A PARAMETER VALUE To change the parameter’s value operate as follows: 1. Enter the Programming mode by pressing the Set + n keys for 3s (the “°C” or “°F” LED starts blinking). 2. Select the required parameter. Model Universal-XR is a 71x29 mm format microprocessor based controller, suitable for applications on high, medium or low temperature refrigeration units. It is provided with three relay outputs to control compressor, defrost - which can be both electrical or hot gas - and evaporator fans. “Dixell S.p.A.” (see address) with a detailed description of the fault. • Consider the maximum current which can be applied to each relay (see Technical Data). • Ensure that the wires for probes, loads and the power supply are separated and far enough from each other, without crossing or intertwining.